Pelco C1973M-B Manuale Utente

MRD1400HZ16Camera ControlInterface for theCC1400HZ16Installation/Operation ManualC1973M-B (8/03)®Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA •

10 Pelco Manual C1973M-B (8/03)CONTROL, POWER, AND CAMERA CONNECTIONS1. Refer to Figure 8 and Table C. Connect the control wires from the controller t

Pelco Manual C1973M-B (8/03) 11OPERATIONCAMERA OPERATION PELCO CONTROLLER COMMANDZoom In Tilt joystick upZoom Out Tilt joystick downQuickly Zoom In Pr

12 Pelco Manual C1973M-B (8/03)REVISION HISTORYManual # Date CommentsC1973M 10/01 Original version.C1973M-A 8/02 Revised instructions.C1973M-B 8/03 Re

2 Pelco Manual C1973M-B (8/03)LIST OF TABLESTable PageA Baud Rate Switch Settings ...

Pelco Manual C1973M-B (8/03) 3IMPORTANT SAFEGUARDS AND WARNINGSPrior to installation and use of this product, the following WARNINGS should be observe

4 Pelco Manual C1973M-B (8/03)DESCRIPTIONThe MRD1400HZ16 is a camera interface control for Pelco’s CC1400HZ16 Series digitalcolor camera. The unit can

Pelco Manual C1973M-B (8/03) 5MRD ADDRESS SETTINGSA camera address setting is required for the controller/switcher to communicate with theMRD1400HZ16.

6 Pelco Manual C1973M-B (8/03)MRD1400HZ16 INSTALLATION METHODSThere are three methods of installation for the MRD1400HZ16. The unit can be mounteddire

Pelco Manual C1973M-B (8/03) 7Figure 3. DF5/DF8 InstallationFigure 4. Removing the MRD BoardCAMERA BRACKETDOMEMRD1400HZ16AND MOUNT ADAPTER01212POWER L

8 Pelco Manual C1973M-B (8/03)EH3512 SERIES ENCLOSURE INSTALLATIONDo the following to install the MRD1400HZ16 in an EH3512 Series enclosure:1. Remove

Pelco Manual C1973M-B (8/03) 9EH2512 SERIES ENCLOSURE INSTALLATIONTo install the MRD1400HZ16 in an EH2512 Series enclosure:1. Remove the PC board from